How Engine Wear and Engine Deposits Kill HorsepowerPosted by Amsoil, 15th January 2019

Most people equate engine wear and engine deposits with a sudden, catastrophic engine failure that leaves you stranded alongside the road. Engine wear and engine deposits are more likely to erode engine power and efficiency over time. Here’s how it works and what you can do about it.

Buy AMSOIL Online in the UK

Engine compression is power

For your engine to produce maximum power, the combustion chamber must seal completely during the engine compression and combustion strokes. Engine wear and engine deposits can prevent the valves or piston rings from sealing, allowing pressurized gases to escape the combustion chamber and take potential engine power with them.

Buy AMSOIL Online in Norway

 

To illustrate, imagine using a hydraulic floor jack. Pumping the handle will raise the vehicle if the release valve is tightly seated and doesn’t leak. A poorly sealed release valve, however, allows pressure to escape, causing the vehicle to sink to the ground no matter how much you pump the jack handle.

The same principle applies inside your engine. If some of the pressure created during the engine compression and combustion strokes is lost due to valves and piston rings that don’t seal completely, the engine will create less power.

Buy AMSOIL Online in the UK and Europe

Engine wear and deposits reduce engine compression

Over time, engine deposits or valve wear can prevent the valves from closing completely, interfering with a good seal. Engine wear can also interfere with proper valve operation, disrupting optimum fuel/air flow.

If the piston rings do not seal tightly against the cylinder wall, pressurized combustion gases can escape past the rings and enter the crankcase, taking potential power with it.

Buy AMSOIL in Finland

 

Worn or stuck piston rings produce the same effect. The rings are designed to move freely in their grooves and press tightly against the cylinder wall. They should form a seal that prevents fuel/air from escaping. Ring wear can interfere with formation of a tight seal. Likewise, engine deposits can cause the rings to stick in their grooves, also preventing a good seal. As a result, some fuel/air escapes the combustion chamber during engine compression, reducing power. On the combustion stroke, pressurized gases can blow by the rings and travel down the cylinder wall and into the oil sump, taking potential power with them. This is what’s meant when someone says an engine has lost compression.

Buy AMSOIL Online in the UK and Europe

AMSOIL Signature Series helps prevent the problem

AMSOIL Signature Series Synthetic Motor Oil provides…

Its outstanding performance helps prevent deposits and wear that rob engines of horsepower, helping preserve that like-new feeling you crave when driving.

To prove it, we installed Signature Series 5W-30 Synthetic Motor Oil in a Ford F-150 with a new 3.5L Eco-boost engine to test its ability to protect turbocharged direct-injection (TDGI) engines from torque and horsepower loss during extended drain intervals up to 25,000 miles. Power sweeps were done at the beginning and end of the test to evaluate horsepower and torque retention. As the video shows, Signature Series helped maintain engine performance throughout the 100,000-mile test.

WHERE TO BUY AMSOIL

 

*Based on independent testing of AMSOIL Signature Series 0W-20, in ASTM D6891 as required by the API SN specification.

**Based on proposed ILSAC GF-5 Plus specification.

Back to blog

Next post

NEWSLETTER SIGNUP

I accept AMSOIL Privacy Policy

Thank you! Your email address has been registered.

About cookies on our website

We use cookies to give you the best experience on our site. By continuing to browse, you are agreeing to their use. Read more...